The Fenix PD35 – 1000 Lumens Tactical LED Torch remains in it’s pocket-size form but surpasses the traditional PD35 in performance and tactical employment. Designed with the military and law enforcement professionals in mind, this flashlight is measured at less than 14cm (5.5 inches) long and features up to 1000 lumens in turbo output while throwing it’s beam a distance up to 200 meters. In Outdoor Mode, the PD35TAC delivers six output modes including a variable strobe. Switch to the new Tactical Mode to activate rear-switch only operation for fast, simplified mode selection of momentary, turbo, low and strobe. The PD35 TAC is powered by two CR123A or single rechargeable 18650 batteries ( Not Included ).
SPECIFICATIONS
- Cree XP-L (V5) LED with a maximum output of 1000 lumens
- Output and Runtime:
- 1000 Lumens – 1h10mins
- 500 Lumens – 2h55mins
- 200 Lumens – 8h30mins
- 60 Lumens – 29h15mins
- 8 Lumens – 140hrs
- 1000 Lumens – Strobe
- Dimensions:
- Length: 137mm
- Diameter: 25.4mm
- Weight: 89g excluding battery
What’s Included:
Fenix PD35 TAC Flashlight, Lanyard, Spare O-ring, Holster, Spare rubber boot switch.
OPERATIONS
Mode Switching
When the light is on, long press on the side switch for 3 seconds till the LED flashes twice at Low output, and then to cycle through Tactical Mode → Outdoor Mode.
Tactical Mode
ON/OFF
Fully press on the tail switch to turn on the light, press once again to turn it off
Output Selection
Slightly click the tail switch to turn the light on temporarily, release it the light will go out, click the tail switch again the light will cycle through Turbo → Strobe → Low.
Continue to fully press on the tail switch after selecting the needed output mode, the light will last on present output mode
Notice: 1. Under this mode, Turbo mode is defaulted when the light turned on
2. Under this mode, the side switch only works on mode changing
Outdoor Mode
ON/OFF
Slightly click the tail switch to turn the light on temporarily, release it the light will go out
Fully press on the tail switch to turn on the light, press once again to turn it off
Output Selection
With the light on, single-click the side switch to cycle through Eco→Low→Mid→High→Turbo.
Strobe Mode
With the light on, long press the side switch for 1 second to enter Strobe mode, click the side switch again to turn back to general mode
Notice: 1. Under this mode, the flashlight memorizes the last used output mode and the next time you turn it on, it will recall that previously used output.
2. Turbo Mode: This output mode work within the LED tolerance in accordance with the battery capacity. If it is not Fenix ARB-L2-3400 18650 rechargeable Li-ion battery, the light brightness will gradually decrease because of the battery capacity limitation. Due to the protective setup of automatically turning to High from Turbo after working 5 minutes, the runtime of the Turbo brightness level is the accumulated time.