The Fenix PD35 V2.0 Digital – 1000 Lumens is destined to carry forward on Fenix’s most popular flashlight. Fitted with the Cree XP-L HI V3 LED, this light delivers a maximum 1000 lumens at a distance of 820 feet (250 meters).
SPECIFICATIONS
- Cree XP-L HI V3 LED with a maximum output of 1000 lumens
- Output and Runtime:
- 1000 Lumens – 2h50mins
- 350 Lumens – 5h10mins
- 150 Lumens – 12h25mins
- 50 Lumens – 29h30mins
- 3 Lumens – 430hrs
Dimensions:
- Length: 138 mm
- Diameter: 23 mm
- Weight: 3.1 oz. (88g) weight excluding batteries
Batteries
- 1 x 18650 ( Not Included )
Included:
Holster, lanyard, two spare O-rings and spare rubber switch boot
OPERATIONS
Switches
The tail switch is the tactical switch, and the side switch is the functional switch.
ON/OFF
Tap
Slightly tap the tactical switch to momentarily turn on the light, release it the light will go out.
Fully press
Fully press the tactical switch to constantly turn on the light, press once again to turn off the light.
Output Selection
With the light switched on, single click the functional switch to cycle through Eco→Low→Med→High→Turbo.
Strobe
With the light switched on, press and hold the functional switch for 0.5 seconds to enter strobe, click once again to return back to General mode.
Boot-up Battery Level Indication
Each time the light is turned on, the battery level indicator will automatically display the battery status for 3 seconds.
Green constant on: saturated
Green flashes: sufficient
Red constant on: poor
Red flashes: critical
Note: This only works on rechargeable LI-ion 18650 battery.
Battery Replacement
Unscrew the tail cap to insert the battery with the anode side (+) towards the light head, then screw the tail cap back on.
Low-voltage Warning
When the voltage level drops below 3V, the flashlight is programmed to downshift to a lower brightness level until Eco output is reached. When this happens in Eco output mode, the battery level indicator will display red and the flashlight blinks every three seconds to remind you to replace the battery. To ensure normal use, the flashlight will work until the battery runs out or
the battery over-discharging protection activates. Note: This only works on rechargeable LI-ion 18650 battery.
Intelligent Memory Circuit
The light memorizes the last selected brightness level on General mode. When turned on again the previously used brightness level will be recalled.
Intelligent Protection
The light will accumulate a lot of heat when it is working at Turbo mode. When the light is overheated up to 65°C or above, the flashlight will automatically step down a few lumens to reduce the temperature; when the temperature is lower than 65°C, the output will gradually return to Turbo output level.