The Fenix HL15 LED Headlamp is designed with the runner in mind. This headlamp is equipped with a reflective headband that directs sweat away from your eyes, a neutral white LED for better color rendering and two red LEDs for better night vision or to use as a flashing alert. Protected by its IP67 dust-proof and water resistance, and powered by two AAA batteries, this light-weight headlamp is perfect for running on the road in any condition.
SPECIFICATIONS
- Cree XP-G2 R5 neutral white LED and Nichia red LED with a maximum output of 70 lumens
- Output and Runtime:
- 400 Lumens – 1 h
- 130 Lumens - 8 hrs
- 70 Lumens - 13 hrs
- 30 Lumens - 33 hrs
- 4 Lumens – 110 hrs
- 1 Lumens - 40 hrs (Red)
- 30 Lumens - 66 hrs (SOS)
- 1 Lumens - 80 hrs (Red Flash)
- Dimensions:
- Length: 62mm
- Diameter: 39.5mm
- Head: 37mm
Weight:
- 55g excluding battery
What’s Included:
- Fenix HL16 Headlamp, Headband, Charging cable
OPERATIONS
General Mode
ON/OFF
Press and hold the switch for 0.5 seconds to turn On/Off the headlamp.
Output Selection
When the lamp is on, single-click the power switch to cycle through Low→Med→High→Turbo.
Intelligent Memory Circuit
The headlamp memorizes the last-used brightness level in the General Mode. The next time it is turned on, the previously used brightness level is recalled.
Red Light
Single-click the switch to switch on the red light, single-click once again to activate the red flash, another single-click to turn off the red light.
Intelligent Overheat Protection
The headlamp will accumulate a lot of heat when used at high output levels for extended periods. Take care when touching the lamp surface.
When the lamp reaches a temperature of 65C or above, the lamp will automatically step down by a few lumens to reduce temperature.
When the temperature reduces, the output will return to previously selected output level.
If the headlamp will not be used for an extended period, remove the battery, or the headlamp could be damaged by electrolyte leakage or battery explosion.
Battery Replacement
Lower the holder to 60°angle, and press the joint of the holder and the headlamp with the thumb.
Grasp the buckle hole with the thumb of the other hand then pull up.
Insert the batteries in accordance with the polarity mark, and close the battery cap.
Headlamp Strap Assembling
Step1: Attach the head strap to the headlamp by first sliding the band down to the bottom of the slot, then hooking the top edge under the top slot.
Step 2: Slide the plastic buckle to adjust the headband.
Disassembling the sealed head can cause damage to the headlamp and will void the warranty.
- Fenix strongly recommends using high-performance Ni-MH rechargeable batteries to get most out of this high-power headlamp.
- Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with an approved spare.
- Periodic cleaning of the battery contacts improves the headlamp’s performance as dirty contacts may cause the headlamp to flicker, shine intermittently or even fail to illuminate for the following reasons:
A: The batteries may need replacing.
Solution: Replace batteries (Please confirm the correct installation of anode and cathode).
B: The threads, PCB board contact or other contacts may be dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.