The Fenix LD02 V2.0 – 70 Lumens LED Torch is a super compact penlight that is perfect for every day carry (EDC). This penlight features three brightness levels of very warm 3000K white light plus a 365nm UV light; both of which are operated by the stainless steel tail switch. Powered by one included AAA battery, this light delivers a maximum output of 70 lumens. Waterproof and dustproof, the LD02 V2.0 will be your go to penlight for every day lighting needs.
SPECIFICATIONS
- Cree XQ-E HI LED (90-CRI/ 3000K warm white) with a maximum output of 70 lumens
- Output and Runtime:
- 70 Lumens – 40mins
- 25 Lumens – 2h40mins
- 1 Lumens – 75hrs
- 200mW – 4hrs
- Dimensions:
- Length: 92mm
- Diameter: 13.5mm
- Weight: 24g excluding battery
- What’s Included:
- Fenix LD02 V2.0 Flashlight, AAA, Spare O-ring.
OPERATIONS
ON/OFF
Fully press the tail switch to turn on/off the light.
Output Selection
With the light switched on, tap the tail switch to cycle through Low→Med→High→UV.
Battery Replacement
Unscrew the head to insert the battery with the anode side (+) towards the light head, then screw the light head back on.
Intelligent Memory Circuit
The light memorizes the last selected brightness level. When turned on again the previously used brightness level will be recalled.
Time-limited Downshift
The light will accumulate a lot of heat when used on High output level for extended periods. When the light has been used on High for 1.5 minutes, the light will automatically step down by a few lumens until 50 lumens is reached to reduce the temperature. High mode can be re-selected.
Usage and Maintenance
- Disassembling the sealed head can cause damage to the light and will void the warranty.
- Fenix recommends using an excellent quality battery.
- Fenix strongly recommends using high-performance Ni-MH rechargeable batteries to get the most out of this light. Alkaline batteries will reduce the runtime relatively.
- If the light will not be used for an extended period, remove the battery, or the light could be damaged by electrolyte leakage or battery explosion.
- Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with an approved spare?
- Periodic cleaning of the battery contacts improves the lamp’s performance as dirty contacts may cause the lamp to flicker, shine intermittently or even fail to illuminate for the following reasons:
A: The battery needs replacing.
Solution: Replace battery (Ensure battery is inserted according to the manufacturer’s specifications).
B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.